Infinity M30 - Manual (Page 15)

1. To identify which program is running, press PROGRAM NUMBER.
NOTE: The program number cannot be changed using while the program is running.
2. To determine the time remaining for the completion of the program, press NIGHT TIME (DELAY START).
The time remaining appears on the Main Display for 5 seconds.
3. Any individual parameter can be increased or decreased during the actual running of all 30
programs.
NOTE: HEAT RATE cannot be changed to "NO" in the stage currently running or in the
stages already completed.
4. To change a parameter while a program is running, press ENTER / REVIEW to advance to the desired
STAGE and parameter (i.e. HEAT RATE, TEMP or HOLD TIME). Initially, STAGE 1 will appear.
Any parameter can be increased or decreased by pressing or .
5. Any program can be stopped or started by pressing the START / STOP button.
6. If a program is edited while running and the HEAT RATE in STAGE 2, 3 or 4 is set to "COOL" but the
corresponding TEMP programmed is entered to heat to a higher temperature than the previous stage,
the Infinity will try to heat with a 0°F / Min (0°C / Min) HEAT RATE. In this case, when NIGHT
TIME (DELAY START) is pressed, 99:99 (Hr : Min) flashes on the Main Display, indicating that the
program cannot be completed.
OPERATION
EDIT WHILE A PROGRAM IS RUNNING (Figure 1)
14
°
°
°
°