Infinity M30 - Manual (Page 5)

DISPLAY DESCRIPTION
1. NIGHT TIME Press to start a delayed program. The number entered is the time
(DELAY START) required for the program to be COMPLETED AND READY TO CAST.
When a program is running, press to display the time remaining to
complete the program.
2. START / STOP Press to start or stop a program.
3. Press to increase a number. The longer the button is pressed, the
faster the numbers change.
4. Press to decrease a number. The longer the button is pressed, the
faster the numbers change.
5. ENTER / REVIEW When programming or reviewing a program in process, press to
advance to the next parameter.
6. PROGRAM SELECT Press to select a program or to review the program currently running.
7. STAGE 1-2-3-4 While programming, the number of active stages are illuminated. In
the burnout process, the current STAGE flashes.
8. °F and °C Identifies the temperature scale.
9. °/ MIN Identifies the heat rate.
10. HH : MM Indicates time. When flashing it indicates that a power failure has
occurred.
11. Main Display A. The 4 digit display indicates the chamber temperature.
B. When programming or reviewing, indicates PROGRAM NUMBER,
NIGHT TIME (DELAY START) (time to completion), HEAT RATE,
TEMP and HOLD TIME.
C. Displays special words and error codes.
12. Program Status Graph Indicates status of the burnout process.
13. Door Interlock Shuts off electrical power from the heating plates
Safety Switch when the furnace door is opened.
FRONT PANEL (Figure 1)
4
KEY PARTS IDENTIFICATION AND EXPLANATION
°
°