Infinity M30 - Manual (Page 9)

When a program is completed, 20 "beeps" sound every 15 minutes to remind the operator that the
material is ready to cast.
1. Be sure the Infinity is in the idle mode - no program us running.
2. Press and (while holding) press PROGRAM NUMBER to display the status of the "beep."
"ON" indicates the beep is active. "OFF" indicates the beep is inactive.
3. Use either of the to turn the "beeps" on or off.
4. To return to the idle mode, wait 7 seconds or press STOP / START twice. (If STOP / START
is pressed once, cycle starts.)
INSTALLATION
TO TURN THE “BEEP” ON AND OFF (Figure 1)
8
°
°
°