4 adjusting the arm width, Push the arm in or out to the desired position, Arm tube – Invacare Lynx L-4 User Manual
Page 33: Figure 7.4 adjusting the arm width, 5 replacing armrest pads, For this procedure, refer to figure 7.5, Remove the old armrest pad, Arm pad, Figure 7.5 replacing armrest pads
7 SEAT AND ARMS
33
7.4
Adjusting the Arm Width
1.
Loosen the knob securing the arm tube to the seat frame.
2.
Push the arm in or out to the desired position.
FIGURE 7.4 Adjusting the Arm Width
7.5
Replacing Armrest Pads
1.
Remove the two mounting screws that secure the armrest pad to
arm.
2.
Remove the old armrest pad.
3.
Install new armrest pad and securely tighten with existing mounting
screws.
4.
If necessary, repeat STEPS 1-3 to replace the other armrest pad.
FIGURE 7.5 Replacing Armrest Pads
For this procedure, refer to FIGURE 7.4 on
page 33.
When installing the arms during set up, the four
mounting screws are installed on the seat hinge for
shipping purposes.
Arm
Tube
Seat
Frame
Knob
Arm
Lynx L-3 shown. Lynx L-4 adjusts the same way.
For this procedure, refer to FIGURE 7.5.
Arm Pad
Arm
Mounting