5 installing/removing the rear mounted basket, Warning, For this procedure, refer to figure 12.5 – Invacare Lynx L-4 User Manual

Page 50: Installing, Loosen but do not remove the mounting knob, Install the basket bracket into the accessory tube, Removing, Remove the basket from the bracket, Loosen the mounting knob, Remove the basket bracket from the accessory tube

Advertising
background image

12 ACCESSORIES

Lynx™L-3 & Lynx L-4 Scooters

50

Part No. 1143205

12.5 Installing/Removing the Rear Mounted Basket

Installing

1.

Loosen but DO NOT remove the mounting knob.

2.

Install the basket bracket into the accessory tube.

3.

Thread the mounting knob into the welded nut on the accessory

tube. Securely tighten.

4.

Align the mounting clips on the bracket with the slots on the basket

and slide the basket down securely into position.

Removing

1.

Remove the basket from the bracket.

2.

Loosen the mounting knob.

3.

Remove the basket bracket from the accessory tube.

4.

Tighten the mounting knob.

FIGURE 12.5 Installing/Removing the Rear Mounted Basket

ƽ

WARNING
The rear mounted basket is rated for a maximum capacity of ten lbs.
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely.
The installation of the basket and basket bracket onto the back of the scooter seat increases the length of the scooter.

When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise,

injury and/or damage to surrounding property may occur.

For this procedure, refer to FIGURE 12.5.

Rear Basket

Slots

Basket Bracket

Mounting Clips

Accessory

Tube

Mounting

Knob

Insert Into
Accessory

Tube

Advertising