4 installing/removing/using the walker holder, Warning, For this procedure, refer to figure 12.4 – Invacare Lynx L-4 User Manual
Page 49: Installing/removing the walker holder, Reverse this procedure to remove the walker holder, Install the walker holder into the accessory tube, Using the walker holder, Fold walker. refer to walker instructions, Walker must be folded before using walker holder, Hang folded walker on walker holder hooks
12 ACCESSORIES
49
12.4 Installing/Removing/Using the Walker Holder
Installing/Removing the Walker Holder
1.
If necessary, loosen but DO NOT remove the mounting knob.
2.
Install the walker holder into the accessory tube.
3.
Thread the mounting knob into the welded nut on the accessory
tube. Securely tighten.
Using the Walker Holder
1.
Fold walker. Refer to walker instructions.
2.
Hang folded walker on walker holder hooks.
3.
Secure walker with hook and loop straps.
FIGURE 12.4 Installing/Removing the Walker Holder
ƽ
WARNING
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter.
When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
For this procedure, refer to FIGURE 12.4.
Reverse this procedure to remove the walker holder.
Walker MUST be folded before using walker
holder.
Walker Holder
Accessory
Tube
Mounting
Knob
Hook and
Loop Strap
Hook
Insert Into
Accessory Tube