Intermec NORAND 600 User Manual
Page 32
SECTION 4
Troubleshooting
4-2 NORAND
R
600 Series Industrial Mobile Computer User’s Guide
Table 4-1 (continued)
Basic Troubleshooting
Condition
Solution
The Power
Status LED
Starts Blinking
The Power Status LED on the front
panel of your mobile computer
informs you of the status of your
battery pack when it is connected to
a charging device. The Power Status
LED reads:
Off when in a normal operating
mode;
Blinking red when the battery is
low;
Continuous red when charging;
Continuous green when done
charging;
Blinking green when in a standby
mode.
Mobile Computer
Will Not Power
Up, Screen is
Blank.
1. Battery is
Critically Low.
2. Ensure that your computer has
been on a charger for at least five
minutes, then remove from the dock
and perform the reset procedure. The
display will then be active.
3. Continue to charge your mobile
computer for 4 hours to ensure that
the battery is fully charged.
Mobile Computer
Will Not Turn ON
When Placed In
A Dock
1. Ensure the dock is plugged in and
your computer is securely seated in
the dock..
Mobile Computer
Shuts Down
During
Operation.
1. You may have a very low battery,
try recharging the battery.