IBM Partner Pavilion T400F User Manual
Page 102
5. Place the tape drive so that the front faces you, then tilt it on its left side (see
6. At the bottom of the drive, locate the access hole (
1 in Figure 32).
Attention:
In the following steps, do not allow drive components
to touch the head
2 . Damage may result to the head.
7. Insert a 2.5-mm allen wrench into the access hole and position the wrench so
that it is seated in the screw of the supply reel motor.
8. With clean needle-nose pliers, grasp the end of the leader pin and pull it out of
the cartridge so that you can grip it with your fingers (see
3 in Figure 32).
Note: If the leader pin is not connected to the tape, set the pin aside. After
you remove the cartridge, reattach the pin (see “Repositioning or
Reattaching a Leader Pin” on page 55).
Figure 32. Rewinding the leader pin into the tape cartridge
90
IBM TotalStorage LTO Ultrium 2 Tape Drive