IBM Partner Pavilion T400F - Manual (Page 38)

Step 5. Mount the Tape Drive into the Enclosure
The Ultrium 2 Tape Drive may be shipped with or without a front bezel (see 1 in
Figure 8).
To mount the Ultrium 2 Tape Drive into an enclosure:
__ 1. Remove the cover of your enclosure (refer to the instructions in the
enclosure’s documentation).
__ 2. Place the drive into the enclosure so that its tape load compartment faces
the tape load compartment of the enclosure.
__ 3. Insert two 6-32 screws into the mounting holes 2 on the side brackets of
the chassis.
Attention: When inserted into the Ultrium 2 Tape Drive, the length of the
mounting screws must not exceed 3.5 mm (0.14 in.) inside the chassis. If the length
exceeds this measurement, the tape drive may become damaged.
Figure 8. Mounting holes on Ultrium 2 Tape Drive. The holes are located on both sides of the
drive. The tape drive is shown with a front bezel.
26 IBM TotalStorage LTO Ultrium 2 Tape Drive