Intellinet Network Solutions PRO SERIES INT-PSNC-UM-1106-06 - Manual (Page 37)

- 37 -
Set IP address, Subnet Mask, Gateway Address
To set the IP address, subnet mask and gateway address manually, select "manually" in the
combo box. If you have any trouble configuring network system information, contact your
network administrator. Knowledge about IP addresses and TCP/IP is required for the
configuration task.
Set DHCP
When selecting "using DHCP," the IP address, subnet mask address and gateway address are
being obtained from a DHCP server. Users in a local network area may check the IP address
through IP Installer.
NOTE: If you select "DHCP," you may see the rebooting message "Now the Network Camera is
rebooting to apply the changes..." on the Web browser. After completion of the reboot, the
Status LED blinks once per second. (Confirm that the Operating Status LED blinks after
selecting "DHCP" and the rebooting process to ensure your new setting took effect.)
To select DHCP, you must have a DHCP server in the network. Otherwise, the IP address will
be rebooted automatically as the previous IP address. It can take about 4 minutes for booting.
After rebooting, re-enter the previous IP address. You may see the fail message from the
"Network Configuration" page.
Send an IP address to Email
To send camera system information (camera name, camera location, DHCP IP address), click
on a text box and enter your e-mail address. (You should configure your SMTP server
information first.)
Web Server Port Number
Set up the port number for the Web server. (The default port number is "80"; users can select
from 80 to 1023.)
HTTPS Port Number
The camera's SSL encryption uses port 443 by default. You can adjust the value.
Image Transfer Port Number
Set up the port number for the video/image transfer. (The default port number is "40001"; users
can select from 8000 to 65535.)
Audio Send Port Number
To set the port number for the audio transfer to the connected camera client. (The default port
number is "40008" and users can select from 8000 to 65535.)
Audio Receive Port Number
Set the port number for the receiving audio from a connected camera client. (The default port
number is "40007"; users can select from 8000 to 65535.)
Upgrade Port Number
Set up the port number used for firmware upgrades. (The default port number is "9000"; users
can select from 8000 to 65535.)
PTZ Port Number
NOTE: PTZ control is not available on these Pro Series Network Camera models.
ETSP Port Number
To set the port number for ETSP (Event Trigger Setting Saving Program). The default is
"11000"; users can select from 8000 to 65535. Refer to section 9 for instructions on the ETSP
client.