Intellinet Network Solutions PRO SERIES INT-PSNC-UM-1106-06 - Manual (Page 92)

- 92 -
Appendix B: Accessing the camera via HyperTerminal
NOTE: This section is for advanced users only.
HyperTerminal is a basic program for Windows 9x/NT/2000XP/Vista. A PC can communicate
with external devices through the serial port by using this program. The steps you should take to
set the HyperTerminal are as follows with a Windows 2000 OS. The camera can be
programmed via HyperTerminal, but only a few options are available. Programming the camera
via HyperTerminal has no advantage over the installation via IP Installer or the Web browser.
However, for diagnostic purposes this access method can be quite useful.
1. Go to Start -> Programs -> Accessories -> Communications ->HyperTerminal. Select one of
the icons and then enter an appropriate name in the box.
2. Select a serial port of the PC, then click "OK." (Usually COM1 or COM2 is recommended.)