Intellinet Network Solutions PRO SERIES INT-PSNC-UM-1106-06 - Manual (Page 57)

- 57 -
When auto mode is selected, click on the select
button to open up the configuration page that holds
additional parameters.
“Delay”: Specify the time (in s) which the camera
delays switching from one mode to another. If you set
the value to “30”, the camera will not immediately
switch the color mode when the start of end level has
been reached, but will wait for 30 seconds to change
the mode. This way the camera will not quickly
switch between the modes, if there are rapid
changes in light level. Instead, the light level has to change for 30 seconds before the mode
changes.
“Start Level”: Specified the light level at which the camera activates the black and white mode.
“End Level”: Defines at what light level the camera should re-activate the color mode.
Note:
If delay value “0” is specified, the auto mode becomes inoperable.
The auto mode only operates, if AGC (Automatic Gain Control) is activated.
If the start and end levels are higher than the AGC level, the auto mode does not operate
Also, the auto mode does not function in fixed shutter mode.
”PRIVACY” – Privacy Masking / Privacy Zones
Privacy masking is a feature that is used to protect personal privacy by concealing parts of the
image from view with a masked area. Examples of a privacy masking application use would be
masking windows of domestic properties or car number plates which are not subject to
surveillance.
This example shows an active
privacy mask. The INTELLINET
network camera allows you to define
up to four different privacy zones.
In order to utilize the function, use the arrow-right key
and set it to on. Once activated, you will see four
squares appearing as an overlay in the video image.
Click on the select button to open up the privacy
function configuration page.