Intermec PB41 - Manual (Page 14)

14 PB41 Printer Quick Start Guide
6 Push down the paper release lever and insert the paper into
the paper well with it resting in the paper rod clips.
7 Press the red button while the printer is on and it will feed
paper. You will need about two inches of paper coming out of
the mechanism.
8 Lower the cover while placing the extra paper though the tear
bar.
9 Close Latch Cover and tear off extra paper.
Turning the Radio ON and OFF
1 To turn the radio on, push the blue illuminating button, or
plug the serial cable into the printer.
S You can tell the radio is on when the light is ON and the
radio is off when the light is OFF.
S The blue illuminating button does a slow flash or blink when
the radio is ON and the printer controller is asleep.
S The blue illuminating button flashes or blinks at a faster rate
when the radio is ON and the printer controller is awake.
You may hear a single beep when the printer is ready to print.
Note: Once the radio is turned ON, the radio stays
“ON” and also always stays in the “listen” mode.
When the radio is turned “OFF”, the radio shuts
down and the printer becomes a serial printer.
Radio On/Off
blue illuminating
button