Intermec PB41 - Manual (Page 9)

9 PB41 Printer Quick Start Guide
Beep Indicator (continued)
Indicates Number of Beeps
8 short beeps CRC error in firmware. Redownload
firmware.
10 short beeps Error writing to communication con-
troller firmware. Redownload firmware.
Determining Current Battery Power
To determine the current charge on each battery pack, print out
a self-test by pressing and holding the red self-test button for
four seconds. If the battery is good, you will see the abbreviation
for the word “GOOD” next to the Battery voltage (Batt1 or
Batt2) print out.
This printer has a built in low battery detector. When the print-
er’s battery voltage is low, the printer beeps three times, indicat-
ing a Low Battery Warning. This only happens if the printer is
awake.
Printer Self-Test
Push the red button and hold for about four seconds to print a
self-test.
Self-Test button
The following is an explanation of the Self-Test print-out.