Intermec PB41 - Manual (Page 15)

15 PB41 Printer Quick Start Guide
2 To turn the radio off push the blue illuminating button
again.
S Pressing the blue illuminating button to turn the radio off
you will hear a double beep (sounds like a chirp).
Replacing A Battery Pack
Use only the battery pack designed for your PB41
Printer. Use only the Intermec 2200 mAh Li-Ion
battery p/n 320-088-101. Using any other battery
may present a risk of fire or explosion. The
battery used in your PB41 Printer may present a
fire or chemical burn hazard if mistreated. Do not
disassemble, heat above 212
°F (100°C), or
incinerate.
1 Open the cover and push the battery lock tabs away while
lifting up the battery. The battery pack fits very tightly so it
takes some effort to remove them.
2 Insert the new battery by putting the non contact area of the
battery in first towards the center.
3 Push down on the battery near the battery lock tabs. Ensure
that the battery is completely seated and tab fits over the top
of the battery.
4 Charge the new battery.
5 Properly dispose of the old battery and keep batteries away
from children.
Battery lock tabs
(one on each side)
Center battery support posts
Battery packs