ICP DAS USA RS-405/405F - Manual (Page 45)

Industrial Redundant Ring Switch – RS Series User Manual
TDRS4050601 ll
Relay Setting
Relay Setting section allows you to monitor or configure current settings of Relay output.
There are three kinds of relay output that you can set up with: Link Lose, Communication
Lose, and System.
 Link Lose relay output:
To set up the relay output for port(s), please check the square box in front of the port.
After you are done with your selections, please click
button. When there is a link
loss occurs on the port(s) you check, relay output will be activated. A warning sign will
also be shown on Hardware Status page.
Note that Preview value is for you to easy preview the mask value when you are checking
the ports you
’d like to set relay output for, this value will be effective only after you click
button.
 Communication Lose relay output:
To set up the relay output for port 1, port 2, please switch SW1 jumper 6 to “on” position
and click “restart” button; for port 3, port 4, port 5, please switch SW1 jumper 5 to “on”
position and click “restart” button.
Check the square box in front of the port you ’d like to set relay output for. After you are
done with your selections, please click button. When there is a communication loss
occurs on the port(s) you check, relay output will be activated. A warning sign will also be
shown on Hardware Status page.
Note that Preview value is for you to easy preview the mask value when you are checking
the ports you ’d like to set relay output for, this value will be effective only after you click
button.
 System relay output:
This section enables you to configure relay output activation status when there is power
fail occurring on power 1 or power 2, or when the switch is being selected as the master
switch. To set relay output for Power 1, please check the square box in front of Power 1.
To set relay output for Power 2, please check the square box in front of Power 2. To set
relay output when this switch is selected to be master switch, please check the square
box in front of Master.