ICP DAS USA RS-405/405F - Manual (Page 65)

Industrial Redundant Ring Switch – RS Series User Manual
TDRS4050601 fff
Event Type 1:Power 1 Error
Power 1 fail , Ethernet Switch can ’t receive signal from Power 1.
Event Type 2: Power 2 Error
Power 2 fail, Ethernet Switch can ’t receive signal from Power 2.
Event Type 3: RS-232/RS-485 Connection Error
Indicate disconnected serial cable of RS-232 port is detected.
A warning message will be displayed as follow:
Event Type 4: Link Error
Indicate disconnection of Link or Communication Status detected. You will see the
warning sign when there is a disconnection:
Link Status disconnection (for Advanced Interface)
Communication Status disconnection (for Advanced Interface)
Link Status or Communication Status disconnection (for Basic Interface)
Event Type 5: Firmware Error
Indicate there is firmware error detected
Event Type 6: Power or RS-232/RS-485 Connection Error
Power fail or RS-232/RS-485 disconnection.
Event Type 7: This switch has been assigned as the master switch.
If you set the master mask for system, this message will be displayed when this switch is
assigned as the master switch.