Invacare PRONTO R2-250 - Manual (Page 19)

19
F
R
O
N
T
R
I
G
G
I
N
G
S
FRONT RIGGINGS PROCEDURE 3
FIGURE 10 - ADJUSTING THE
REMOVABLE FOOTBOARD HEIGHT
Caplug
Cap
Mounting
Screw
Caplug
Washer
Flat
Washer
Nut Height Adjustment
Bracket
Footboard
Bracket
Two (2) Large
Washers
Support Tube
Footboard Bracket
Nut
Flat
Washer
Mounting
Positions
Threaded
Arm
Height
Adjustment
Bracket
DETAIL “A”
DETAIL “B”
REMOVING THE REMOVABLE
FOOTBOARD ASSEMBLY FROM
THE WHEELCHAIR (FIGURE 11)
Removing The Removable Footboard Plate
1. Depress the push pins on the two (2) support tubes
on the removable footboard plate.
2. While performing STEP 1, grasp the removable
footboard plate and pull it away from the two (2) sup-
port tubes on the removable footboard mounting
brackets.
Installing The Removable Footboard Plate
1. Align the two (2) support tubes on the removable
footboard plate with the two (2) support tubes on the
removable footboard mounting brackets.
2. Push the two (2) support tubes on the removable
footboard plate onto the two (2) support tubes on
the removable footboard mounting brackets, un-
til the push pins release into the adjustment holes.
WARNING
Make sure the push pins are fully protruding through
the adjustment holes BEFORE using the wheelchair.
Otherwise, injury or damage can occur.
3. Make sure the push pins are completely released.
Push
Pin
Support Tube
Removable
Footboard
Plate
Support
Tube
Removable
Footboard
Mounting
Bracket
Adjustment
Hole
Pull Removable
Footboard Plate Away
FIGURE 11 - REMOVING THE REMOVABLE
FOOTBOARD ASSEMBLY FROM THE WHEELCHAIR
NOTE: Bottom view of wheelchair/footboard shown
for clarity.