Invacare PRONTO R2-250 - Manual (Page 35)

35
FIGURE 1 - REMOVING/INSTALLING SHROUDS
Front Shroud
1/4-Turn Bolts
Rear Shroud
NOTE: Side shrouds are exploded away for clarity.
There is no need to remove side shrouds.
S
H
R
O
U
D
S
PROCEDURE 9 SHROUDS
This Procedure Includes the Following:
Removing/Installing Shrouds
REMOVING/INSTALLING SHROUDS
(FIGURE 1)
Removing Front Shroud
1. Turn the two (2) 1/4-turn bolts that secure front shroud
to the two (2) side shrouds COUNTERCLOCKWISE.
2. Remove the front shroud from the wheelchair.
Installing Front Shroud
1. Position the two (2) 1/4-turn bolts with the two (2)
mounting holes in the side shrouds.
2. Install the front shroud onto the two (2) side shrouds.
3. Turn the two (2) 1/4-turn bolts that secure the front
shroud to the two (2) side shrouds CLOCKWISE.
WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.
Removing Rear Shroud and Rear Storage
Compartment
NOTE: The rear storage compartment is available on
wheelchairs NOT equipped with weight shift basic tilt only.
1. Lift up on rear shroud and remove from wheelchair.
2. Turn the two (2) 1/4-turn bolts that secure the rear
storage compartment to the wheelchair frame COUN-
TERCLOCKWISE.
3. Remove rear storage compartment from wheelchair.
Installing Rear Shroud and Rear Storage
Compartment
1. Position the two (2) 1/4-turn bolts with the two (2)
mounting holes in the wheelchair frame.
2. Install rear storage compartment onto chair frame.
3. Turn two (2) 1/4-turn bolts that secure the rear stor-
age compartment to the wheelchair frame CLOCK-
WISE.
4. Position rear shroud on the two (2) side shrouds and
slide towards the front of the wheelchair until it stops.
5. Press down on the rear shroud until the two (2) clips
secure the rear shroud to the two (2) side shrouds.
Wheelchair
Frame
Rear Storage
Compartment