Invacare PRONTO R2-250 - Manual (Page 46)

46
B
A
T
T
E
R
I
E
S
PROCEDURE 11 BATTERIES
3. Position the battery boxes onto the battery tray in
the following order:
A. TWO (2) connector battery box in FRONT so
that the "open" ends of the connectors are fac-
ing the REAR of the chair.
B. ONE (1) connector battery box in REAR so
that the flying lead is on the RIGHT side of the
wheelchair.
NOTE: Make sure the leads that connect the REAR
battery box to the FRONT battery box are on the same
side.
4. Position retaining straps around each battery box
as shown in DETAIL "B" of FIGURE 7 and clip
retaining strap together.
5. Connect the REAR battery box lead to the FRONT
battery box lead.
6. Connect the FRONT battery box lead to the wir-
ing harness.
7. If necessary, reinstall the removeable footboard.
Refer to REMOVING THE REMOVABLE
FOOTBOARD ASSEMBLY FROM THE WHEEL-
CHAIR in PROCEDURE 3 of this manual.
FIGURE 9 - INSTALLING/REMOVING BATTERY BOXES
Retaining Strap
Rear Battery Box
(One (1) Connector)
Front Battery Box
(Two (2) Connector)
Retaining
Strap Clip
Rear Battery
Box Lead
(Flying Lead)
Front Battery
Box Lead
Front
Battery Box
Lead (To
Wiring
Harness)
Open Ends of
Connector Face
Rear of Chair
REAR OF CHAIR
FRONT OF CHAIR