Removing the diskette drive, Removing the diskette drive -10 – IBM 2193 User Manual
Page 120
Advertising
8-10
IBM Personal Computer User Guide
Removing the diskette drive
If you want to replace the diskette drive, you must follow these steps:
1. Disconnect the power and signal cables from the back of the diskette drive.
2. Pivot the latch that secures the lower drive mounting tray.
3. Slide the drive mounting tray toward the rear of the computer and remove it.
4. Remove the four screws (two on each side) that hold the diskette drive to the
mounting tray.
5. Pull the diskette drive from the mounting tray to remove it.
6. Reverse the procedure to install a new drive.
Advertising