Clock generator configuration -19, Set password -19, Clock generator configuration – IBM 2193 User Manual
Page 97: Set password
BIOS Setup configuration
6-19
Automatic Power On
Use this setting to define automated methods of waking up the computer:
• wake up when the modem senses an incoming ring
• wake up at a future time
• wake up when the LAN senses an incoming data packet
• wake up when the PCIPME signal is active
• wake up when any key in key board is pressed
You can also define the power button override function. You can make the system
power off instantly or after the power button is pressed for four seconds.
ACPI suspend Type
This setting determines the suspend type.
Clock Generator Configuration
The settings in this function allow you to change the clock rate of CPU, SDRAM,
DIMM and PCI bus.
Set Password
In this option, you can set up a password to restrict access to the Setup Utility or to
your system. You can also change or remove the password.
Note:
This setting will be supported when the following are
set.
1. Enable "Ring Power Up Control" under Automatic
Power On in BIOS.
2. Make sure Ring Central FAX or Hyper Terminal in
Windows 98 is running.
3. Make sure the system is in standy mode.
S1(POS)
Power on suspend.
S3(STR)
Suspend to RAM.