Intellinet Network Solutions Wireless G Broadband Router 523431 - Manual (Page 25)

25
The “Disconnect” button causes the router to release the WAN port IP address and
disconnect from the Internet.
The “Connect” button is a manual WAN port IP address refresh function button. If
clicked, the WAN port will re-obtain a dynamic IP address and connect with the
Internet.
Click the “Save” button to save the current configuration, then restart all PCs
connected with router.
Other configuration options:
Physical address Clone: If you want to change a WAN port MAC address, you
can choose this option. If not selected, the WAN MAC address is the default value.
If using this option, the displayed MAC address is your current MAC address. You
can also manually add the WAN port MAC address; without the option, the WAN
port MAC address will restore to its default value.
Allow private IP to be accepted: Allows a WAN port to be assigned a private IP
address.
4.4 Static IP Configuration
If you have a static IP address provided by your ISP, you must choose this option.
1. Turn on the external modem and check the WAN LED of the router. If the WAN
LED is off, check the network cable between the external modem and the WAN
port.
2. Click “Basic Setup” —> “WAN Setup” as shown: