Intellinet Network Solutions Wireless G Broadband Router 523431 - Manual (Page 9)

9
WAN Connect xDSL/cable modem or LAN cable.
LAN 1–4 Connect personal computers, hubs or switches.
3. LOCAL COMPUTER SETUP
The Wireless G Broadband Router acts as a DHCP server, which means that it
provides IP addresses to all connected computers. By default, Windows, Linux and
Mac OS systems will try to obtain an IP address from a DHCP server, if present,
and no configuration of the computer’s IP settings are necessary. In order to test
your IP settings, simply start your computer while connected to the router. Then
open your Web browser and open http://192.168.0.1.
If the router’s Web Admin screen appears, you can skip this section and proceed
directly to Section 4.
If you are unable to open the router’s Web Admin screen, follow whichever
instructions below apply to the operating system you use.
3.1 Windows 2000 Setup
1. Install the Wireless G Broadband Router.
2. Start Windows 2000 and check whether the LAN LED is on or off. If off, confirm
the connection between the computer and the router is correct.
3. Click “Start” —> “Setting” —> “Control Panel.”
Antenna
Power Port
Reset
WAN
LAN 1 ~ 4