Intellinet Network Solutions Wireless G Broadband Router 523431 - Manual (Page 31)

31
PPPoE (ADSL), Dynamic IP and Static IP setup procedures are illustrated in
sections 4.2, 4.3 and 4.4, respectively.
The Wireless G Broadband Router not only can connect to the Internet by cable,
but also by wirelessly connecting to another access point, called “Wireless Client
Mode.” In this mode, the router does not accept any wireless connections from any
PC: PCs can only connect to the router via RJ-45 cable.
To activate this mode, check the option “Use Wireless Port for Internet Connection”
and click ” Apply” and “Reload.“
NOTE: If the client mode is activated, no wireless connections from any
PC will be accepted by the router. Also, if client mode is activated, the
router’s WAN port is disabled.
4.6.2 Wireless Setup
Click ”Basic Setup” —> “Wireless Setup.”
This page shows the basic wireless parameters.
Status: Shows wireless operational status (on/off, AP/Client mode).
Operation: Activate/Deactivate the wireless function.
SSID: Define the SSID of your wireless network.
Mode: If some of your wireless cards are older and do not support the Wireless G
standard, activate “g and b.” But if all of your wireless cards support Wireless G
connections, “g only” should be selected for increased wireless performance.