Connect the fan cables to the mid-plane, Install the optical drive cable (optional), Replacing a redundant system fan – Intel SERVER SYSTEM SR2500AL User Manual
Page 117
Intel® Server System SR2500AL User’s Guide
95
12. Connect the fan cables to the mid-plane.
13. Install the large air baffle. For instructions, see
“Installing the Large Air Baffle”
14. Install the bridge board. For instructions, see
Figure 64 “Installing the Bridge
Board into the Server System” on page -73
.
15. Install the optical drive cable (optional).
16. Install the PCI riser assembly. For instructions, see
17. Install the processor air duct. For instructions, see
18. Install the server system cover. For instructions, see
.
19. Plug all peripheral devices and the AC power cable(s) into the server.
Replacing a Redundant System Fan
Note: The fans that are integrated into the power supply cannot be replaced separately. If one of
the fans in the power supply fails, the power supply must be replaced.
The system fans at the front of the server system can be individually replaced if one of
them fails. Use the steps below to replace a system fan.
1. Observe the safety and ESD precautions at the beginning of this book. See
.
2. Remove the server system cover. For instructions, see
.
3. There are no screws to loosen. Lift the failed fan from the module.