Intel SERVER SYSTEM SR2500AL - Manual (Page 52)

30 Intel® Server System SR2500AL User’s Guide
Installing the Front Bezel
Use the steps below if your system includes either the standard front bezel or the front
bezel for the Intel
®
Local Control Panel. The front bezel is optional.
1. At each end of the bezel, line up the center notch on the bezel with the center guide
on the rack handles.
2. Push the bezel onto the front of the server system until it clicks into place.
3. Connect any necessary cables to the front control panel area at the right side of the
server system.
Figure 19. Installing the Front Bezel
Removing and Installing the System Cover
Removing the System Cover
The server system must be operated with the chassis cover in place to ensure proper
cooling. You will need to remove the top cover to add or replace components inside of the
server. Before removing the chassis cover, power down the server and unplug all
peripheral devices and the AC power cable(s).
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
TP02130