Intel SERVER SYSTEM SR2500AL - Manual (Page 86)

64 Intel® Server System SR2500AL User’s Guide
Figure 55. Installing a Full Height Add-In Card
10. Close both retention clips.
Note: Make sure that all empty add-in card slots have filler panels installed.
11. Install the PCI riser assembly into the server system. For instructions, see
“Installing the PCI Riser Assembly” .
12. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct” .
13. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
14. Plug all peripheral devices and the AC power cable(s) into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” .
5. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” .
AF000148
D
C
A
B