Intel SC5400 - Manual (Page 36)

18 Intel® Server Chassis SC5400 User’s Guide
Removing and Installing the Front Bezel
Removing the Bezel Assembly (Pedestal Only)
Caution: Do not rotate the bezel assembly more than 40 degrees or you will damage the bezel
assembly.
Note: The bezel assembly consists of two components, a front door and a sub-bezel.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see
“Removing the Chassis Cover” on
page 16 .
4. Release the two plastic tabs (see letter “A” in the following figure) on the left side
of the bezel assembly to disengage the tabs.
5. Rotate the bezel assembly (see letter “B”) no more than 40 degrees outward.
6. At a 40-degree angle, push the bezel assembly away from the chassis (see letter
“C”).
7. If the bezel assembly does not immediately disconnect from the chassis, tap the
left-hand side of the bezel assembly to disengage the bezel hooks on the right-hand
side of the chassis.
Figure 9. Removing the Front Bezel
AF000557
A
A
B
C