JVC CA-MD9R - Manual (Page 56)

52
English
One Touch Play —————————————————————————
❏ Press the ¤ or ‹ button (or the £ button on the Remote Control).
The power comes on and “TAPE” appears on the display. When a tape is already in the cassette
holder, the tape is played in the direction of the button pressed. If there is no tape in the cassette
holder, the CA-MD9R automatically turns on and “NO TAPE” appears on the display.
Regular Play
If the power is already on, you can use this basic procedure:
1.
Press down the 0 button.
2.
When the cassette holder opens, put a cassette in, with the exposed part of the tape down,
toward the base of the CA-MD9R.
❏ If the cassette holder does not open, turn off the unit, then back on and press down the
0
button again.
3.
Close the holder gently.
4.
Press the ¤ or ‹ button (or the £ button on the Remote Control).
The tape is played in the direction of the button pressed.
❏ The Cassette Deck automatically stops when one side of a tape has finished playing (except
if the deck is in auto reverse mode: see the next page).
Playing the front side Playing the reverse side
❏ To change the tape direction using the Remote Control, press the TAPE DIRECTION button.
Each time you press the button, the tape direction alternates.
To stop playing, press the
7 button.
To remove the tape, press down the
0 button after stopping the play.
Fast Left and Fast Right ——————————————————————
❏ While the tape is stopped, press the 1 button and the tape will wind rapidly to the left side of
the cassette without playing.
❏ While the tape is stopped, press the ¡ button and the tape will wind rapidly to the right side of
the cassette without playing.
TAPE
TAPE
DIRECTION
EN.51-72.CA-MD9R[E]/F 6/16/98, 1:52 PM 52