JVC KD-LX330R - Manual (Page 25)

25
ENGLISH
To adjust the display contrast level
—
CONTRAST
You can adjust the display contrast level among
“01” (dark) to “10” (bright). When shipped from
the factory, the display contrast level is set at
level “05.”
To select the scroll mode — SCROLL MODE
You can select the scroll mode for the disc
information if it consists of more than 12
characters. When shipped from the factory, Auto
Scroll mode is set to “SCROLL ONCE.”
• SCROLL ONCE: Scrolls only once.
• SCROLL AUTO: Repeats the scroll
(in 5-second intervals).
• SCROLL OFF: Cancels Auto Scroll.
Note:
Even if the scroll mode is set to “SCROLL OFF,” you
can scroll the display by pressing DISP for more than
1 second.
To select the subwoofer cutoff frequency
—
WOOFER FREQ
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer. When shipped from the factory,
the subwoofer cutoff frequency is set to “FREQ
MID.”
• FREQ LOW:
Frequencies higher than
50 Hz are cut off to the
subwoofer.
• FREQ MID: Frequencies higher than
80 Hz are cut off to the
subwoofer.
• FREQ HIGH: Frequencies higher than
120 Hz are cut off to the
subwoofer.
To adjust the line input level — LINE ADJ
Adjust the line input level properly when an
external component is connected to the LINE IN
plugs. When shipped from the factory, the line
input level is set at level “00.”
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change from the external component to another
source.
To make the front panel look flat (hiding
the control panel) —
FLAT PANEL
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat. When shipped from the
factory, “FLAT OFF” is selected.
• FLAT ON:
The control panel will not
come out when you turn on
the unit.
To use the control panel,
press
4 so that the
control panel comes out. If no
operation is done for about
10 seconds, it automatically
goes back into the receiver.
• FLAT OFF: You can use the control panel
normally.
Note:
When “FLAT ON” is selected, you can eject a CD by
holding
4
.
EN22-31.KD-LX330R[E]f 2/5/01, 10:10 AM 25