JVC KD-LX330R - Manual (Page 28)

28
ENGLISH
Assigning names to the
sources
You can assign names to CDs and the external
component connected to the LINE IN plugs. After
assigning a name, it will appear on the display
when you select the source.
Sources Maximum number of
the characters
CDs* and Up to 32 characters (up to
CD changer* 40 discs)
External component Up to 12 characters
* You cannot assign a name to a CD Text.
1
Select a source you want to assign a
name to.
2
Press and hold SEL (select) for more
than 2 seconds while pressing DISP.
When you select the CD as the source:
When you select the external component
connected to LINE IN as the source:
3
Select the character set you want
while “
” is flashing.
Each time you press the button, the
character set changes as follows:
4
Select a character.
About the available characters, see page 29.
5
Move the cursor to the next (or
previous) character position.
6
Repeat steps 3 to 5 until you finish
inputting the name.
7
Press the button while the last
selected character is flashing.
The input name is stored in memory.
To erase the input characters
Insert spaces using the same procedure
described above.
Small letter ( ) Capital letter ( )
Numbers and symbols ( )
EN22-31.KD-LX330R[E]f 2/5/01, 10:10 AM 28