John Deere PA01186 CS71 - Manual (Page 13)

13 English
• Place the chain saw on level ground and ensure that no objects
or obstructions are in immediate vicinity which could come in
contact with the bar and chain. Hold the front handle firmly with
the left hand and put your right foot onto the base of the rear
handle, see illustration (A).
• Set the chain brake by pushing the chain brake lever / hand
guard forward (towards the bar), to the Brake Position as
shown in Illustration (B). Refer to Safety-Chain Brake and
Operation-Chain Brake Sections for additional information.
• Move the ignition switch (C) to the start position “I”.
• Pull the choke lever (D) to the fully extended position ( / Full
Choke), as shown in Illustration (E). Depress the throttle
trigger lockout (F) and squeeze the throttle trigger (G), depress
the half-throttle lock button (H) with your thumb and release the
throttle trigger (G). This sets the throttle trigger to the half-
throttle position.
• Depress the compression relief valve (J). Pull the starter rope
until the first firing of the engine is heard (no more than five (5)
pulls), a new unit may require additional pulls.
NOTE: Compression relief valve automatically resets
after the first firing.
• Push the choke lever (D) completely in to the engine run
position, as shown in Illustration (E).
• Depress the compression relief valve (J) and pull the starter
rope until the engine starts.
• Immediately after the engine has started, depress the throttle
trigger lockout (F), quickly squeeze and release the throttle
trigger (H). This releases the throttle trigger from the half-
throttle position and lets the engine idle. Place chain brake
lever / hand guard into the run position as shown in Illustration
(B). Refer to Safety-Chain Brake and Operation-Chain Brake
Sections for additional information.
NOTE - STARTING WARM ENGINE:
Follow above starting instructions, but do not use the full
choke position for start up.
OPERATION
Breaking-in the Engine
Engine break-in period is approximately 20 hours or 30 tanks of
fuel.
During this period avoid using the chain saw at prolonged high-
speed operation.
Stopping the Engine
Release the throttle trigger (G) and let the engine return to idle. To
stop the engine, move the ignition switch (C) to the “
” stop
position. Do not put the chain saw on the ground when the chain
is still moving. For additional safety, set the chain brake when the
saw is not in use.
In the event that the “
” stop switch will not function, pull the
choke lever out to the fully extended position ( / Full Choke )
to stop the engine.
A
WARNING
Keep body to the left of the chain line. Never straddle the
saw or chain, or lean over past the chain line.
Starting the Engine
C
D
F
H
G
J
Run
Full
Choke
E
Brake
Position
Run
Position
B
Carburetor Adjustment
Before adjusting the carburetor, clean the starter cover vents as
shown in Illustration (K), and air filter as shown in Illustration (L),
refer to Operation-Starting Unit and Maintenance-Air Filter Sec-
tions for details. Allow the engine to warm up prior to carburetor
adjustment.
L K