JVC DR-M150SEK - Manual (Page 42)

Filename [M150SEK_07Timer Recording.fm]
Masterpage:Left+
42
EN
TIMER RECORDING
This function allows you to automatically record a satellite
programme which is timer programmed on your external satellite
receiver. Connect a satellite receiver to the unit’s [L-2 IN] connector
and programme the timer on the satellite receiver. The unit starts
or stops recording by the signals input from the satellite receiver.
After recording, the unit’s power shuts off automatically.
1
Set AL-2 SELECTB to ASAT VIDEO/RGBB or ASAT S-VIDEO/
RGB B. (A pg. 58)
● Also refer to AIMPORTANTB on page 59.
2
Press REC MODE repeatedly to set the recording mode.
3
Press and hold SAT j for about 2 seconds to engage the
Automatic Satellite Programme Recording mode. ASAT jB and
AVB appear on the front display panel and the unit turns off
automatically.
NOTES:
● To disengage the Automatic Satellite Programme Recording
mode, press SAT
j.
● If the unit’s power is off, it is not possible to engage the Automatic
Satellite Programme Recording mode.
● In step 3, if AVB blinks quickly on the front display panel even
though your satellite receiver’s power is off, Automatic Satellite
Programme Recording will not work properly with that satellite
receiver*. If this is the case, perform
AManual Timer
Programming B (A pg. 38) to timer record a satellite programme.
* Some satellite receivers output signals even if the power is off. Automatic
Satellite Programme Recording is not possible with those satellite
receivers.
● AVB blinks on the front display panel while Automatic Satellite
Programme Recording is in progress.
● For timer programming of the satellite receiver, refer to the
instruction manual of the satellite receiver.
● Automatic Satellite Programme Recording is not possible if your
satellite receiver does not have a timer.
● Pressing the unit’s A button while Automatic Satellite
Programme Recording is in progress turns off the unit’s power
and disengages the Automatic Satellite Programme Recording
mode.
● If there are more than one satellite programmes you wish to
record with Automatic Satellite Programme Recording, it is not
possible to set different recording modes for each programme.
● Depending on the type of satellite receiver, the unit may not
record a slight portion of the beginning of the programme or may
record slightly longer than the actual length of the programme.
● If you engage the Automatic Satellite Programme Recording
mode when the satellite receiver’s power is on, the unit will not
start Automatic Satellite Programme Recording even though
AVB
blinks on the front display panel. When the satellite receiver shuts
off once and is turned back on again, the unit starts recording.
● When the Automatic Satellite Programme Recording mode is
engaged, or the unit’s power is turned off after Automatic Satellite
Programme Recording is finished, the unit will not enter the timer
mode even though
AAUTO TIMERB is set to AONB.
● Just Clock (A pg. 66) does not work when the Automatic Satellite
Programme Recording mode is engaged.
Automatic Satellite Programme
Recording
ATTENTION:
● When you record programmes by connecting to a digital
terrestrial receiver (Freeview receiver or similar), perform the
same steps as
AAutomatic Satellite Programme RecordingB
(A pg. 42).
● Be sure not to turn on the satellite receiver before the
programme is executed. Otherwise, the unit will start recording
when the satellite receiver’s power is turned on.
● If you have connected another appliance other than a satellite
receiver to the [L-2 IN] connector, be sure not to engage the
Automatic Satellite Programme Recording mode. Otherwise,
the unit will start recording when the connected appliance’s
power is turned on.
● Automatic Satellite Programme Recording and timer recording
cannot be done at the same time.
REC MODE
SAT j
● Make sure the satellite receiver is connected to the unit’s [L-2
IN] connector.
● Programme the timer on the satellite receiver.
M150SEK_00.book Page 42 Wednesday, June 15, 2005 4:04 PM