JAI CV-M40 - Manual (Page 16)

16
CV-M40
7-1-2. Binning mode (SW1-4)
This switch selects the Binning mode.
OFF
ON
:
:
Normal mode (60 frames/sec.)
Binning mode (120 frames/sec.)
At the Binning mode, please note that vertical resolution would be lower (1/2 approx.) of normal mode.
7-1-3. Ext. trigger/readout modes (SW1-5, SW1-6)
These switches select the ext. trigger/readout mode, as below.
7-1-5. RS 232C interface (SW1-7)
This switch selects the RS 232C interface.
OFF
ON
:
:
All functions can be set by switches and jumpers.
RS 232C interface is activated.
7-1-4. Partial scan (SW1-7)
This switch selects the Partial scan mode. The effective number of lines can be set via RS
232C, or by jumpers.
OFF
ON
:
:
Normal readout mode
Partial scan mode
Ext. trigger mode
Switch setting (OFF : /ON : )
SW1-5 SW1-6
OFF
Edge pre-select
Pulse width control
Frame-delay readout
CAUTION