Installing a transceiver in an ex series switch – Juniper Networks EX8208 User Manual
Page 189
Figure 61: Installing a Line Card with a 4-in. Ejector Lever
9.
Tighten the captive screws on the faceplate of the line card by using the screwdriver.
10.
Verify that the
ON
LED starts blinking in green. When the
ON
LED is lit steadily, the
line card is ready for use. If the
ON
LED does not blink or is not lit steadily, see
“Troubleshooting Line Card Installation on EX8200 Switches” on page 237.
CAUTION: After the
ON
LED is lit steadily, wait for at least 30 seconds before installing
another line card or removing a line card.
You can verify that the line card is functioning correctly by issuing the
show chassis fpc
and
show chassis fpc pic-status
commands.
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or
upgrade of hardware components at
Failure to
do so can result in significant delays if you need replacement parts. This note applies
if you change the type of line card. It does not apply if you replace these components
with the same type of component.
Related Topics
Removing a Line Card from an EX8200 Switch on page 218
•
•
8-port SFP+ Line Card in an EX8200 Switch on page 30
•
40-port SFP+ Line Card in an EX8200 Switch on page 31
•
48-port SFP Line Card in an EX8200 Switch on page 33
•
48-port RJ-45 Line Card in an EX8200 Switch on page 34
Installing a Transceiver in an EX Series Switch
The transceivers for EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
Use only optical transceivers and optical connectors purchased from Juniper Networks
for your EX Series switch.
163
Copyright © 2010, Juniper Networks, Inc.
Chapter 9: Installing Switch Components