Juniper Networks EX8208 - Manual (Page 221)

NOTE: After the configuration is committed, the connectivity between the PC and the
switch might be lost. To renew the connection, release and renew the IP address by
executing the appropriate commands on the management PC or by removing and
reinserting the Ethernet cable.
Related Topics • Connecting and Configuring an EX Series Switch (CLI Procedure) on page 190
• Installing and Connecting an EX2200 Switch
• Installing and Connecting an EX3200 or EX4200 Switch
• Installing and Connecting an EX4500 Switch
• Installing and Connecting an EX8208 Switch on page 125
• Installing and Connecting an EX8216 Switch
195 Copyright © 2010, Juniper Networks, Inc.
Chapter 11: Performing Initial Configuration