JVC SR-DVM700ER - Manual (Page 11)

Masterpage:Right+
EN
11
Filename [DVM700ER_05Name.fm]
INDEX
Page 11 Wednesday, 20 September 2006 10:03
Rear View
A AC Power Cord A pg. 16
B Cooling Fan
● This prevents the temperature from rising inside the unit.
Do not remove it.
● Install the unit so as not to block the area around the fan.
● The unit may become hot when it is turned off, as the cooling
fan on the rear of the unit is not activated. However, the cooling
fan may be activated in the standby mode when
AQUICK
STARTUP B is set to AONB.
C Component Video Output Connectors [COMPONENT
VIDEO OUT (Y/P B /P R )] (HDD & DVD deck only) A pg. 16
D Serial Command Connector (D-SUB 9-PIN) [SERIAL COM.]
A pg. 70
● Use this connector when controlling this unit via a computer.
The cable to be used should be a RS-232C interface cable
(straight type). For details on the RS-232C interface command,
refer to page 70.
E S-VIDEO/VIDEO/AUDIO OUTPUT Connectors (HDD & DVD
deck only)
● These connectors only output DVD/HDD signals and can be
used to connect to a second monitor.
F S-VIDEO/VIDEO/AUDIO INPUT Connectors (L-1) A pg. 51
G S-VIDEO/VIDEO/AUDIO OUTPUT Connectors A pg. 16
H Digital Audio Output Connectors
[DIGITAL AUDIO OUTPUT (OPTICAL/COAXIAL)] (HDD &
DVD deck only)
A pg. 52, 56
I BNC Video Output Connector [VIDEO OUTPUT] A pg. 16
J Remote Input Connector* [REMOTE IN]
* There is currently no compatible remote control unit available.
OUTPUT DV/HDD/DVD INPUT L-1
OPTICAL
HDD/DVD
L
R
DIGITAL AUDIO OUT
COMPONENT
VIDEO OUT VIDEO
AUDIO
VIDEO
AUDIO
PCM/STREAM
L
R
VIDEO COAXIAL
SERIAL COM.
Y
P B
P R
REMOTE IN
OUTPUT HDD/DVD
L
R
AUDIO
VIDEO
S-VIDEO
DV/HDD/DVD
OUTPUT
S-VIDEO
S-VIDEO
B C A
H I
D E G F
J
DVM700ER_00.book Page 11 Wednesday, September 20, 2006 10:03 AM