JVC SR-DVM700ER - Manual (Page 47)

Masterpage:Right+
EN
47
Filename [DVM700ER_11Editing.fm]
EDITING
Page 47 Wednesday, 20 September 2006 10:03
COMPLETED B appears on the TV screen when the tape end is
reached and the tape rewinds automatically.
● Dubbing copyright guarded tape is not possible.
● When dubbing is in progress, o and ON SCREEN buttons are
functional.
Dubbing From DV To DVD
(Dubbing A Part Of A Cassette)
It is possible to select the images on the DV cassette to be dubbed
from the DV deck to the DVD deck using
AMANUALB dubbing.
1
Load the Mini DV cassette you want to dub. Make sure its erase
protection switch is set to
ASAVEB.
● Set ADV AUDIO RECB to the appropriate mode. (A pg. 59)
2
Press DUBBING to access the Dubbing Menu screen.
3
Press selection keys to select ADVNDVDB, then press
ENTER.
4
Select AMANUALB, then press ENTER.
5
Press selection keys to select ASELECT REC. MODEB, then
press ENTER. Press selection keys to select the desired
option, then press ENTER.
6
Press selection keys to select ASELECT SND. MODEB, then
press ENTER. Press selection keys to select the desired
option, then press ENTER.
7
Press G to select ACONFIRMB, then press ENTER. The
confirmation screen appears.
8
Press selection keys to select AEXECUTEB or AAUTO
FINALISE B, then press ENTER for confirmation.
● If the DV deck is in the stop mode, the unit will start dubbing
from the current tape position.
● If the DV deck is in the pause mode, the unit will start dubbing
from the point where the tape was paused after automatically
rewinding the tape for 2 seconds.
● To cancel the dubbing, press o then selection keys to select
ACANCELB and press ENTER to confirm.
9
Upon completing dubbing, the tape stops and ADUBBING
COMPLETED B appears on the TV screen. Press ENTER to
end.
● The tape will automatically be rewound.
NOTES:
● The programme information at the DV deck will not be dubbed.
● When there are blanks on the tape of more than 2 seconds, the
DVD deck will enter into pause mode while playback on DV deck
continues. This also applies to portions of the DV tape that are
damaged or unreadable. The last image is displayed on the TV
screen. Dubbing will resume once recorded portion is detected. If
the blank portion continues until the end of the tape,
ADUBBING
COMPLETED B appears on the TV screen when the tape end is
reached and the tape rewinds automatically.
● Dubbing copyright guarded tape is not possible.
● When dubbing is in progress, o and ON SCREEN buttons are
functional.
About Disc Remaining Display
When dubbing from HDD to DVD, the unit displays the time
information for dubbing by bar meter. By comparing the disc
remaining time and the necessary time for dubbing of the selected
items, it is possible to check if the dubbing can be performed
completely or not.
When performing the High Speed Dubbing
When performing the Just Dubbing
● The unit displays the status on the assumption that the selected
items are dubbed in the lowest transfer rate.
● The total time of a loaded disc is displayed on the right of the bar
meter.
When performing the Manual Dubbing
● The unit displays the status on the assumption that the selected
items are dubbed in the lowest transfer rate.
● The available highest transfer rate is displayed on the right of the
bar meter.
21%
Capacity of a disc Remaining capacity
Dark green: Length of already recorded item
Light green: Length of selected item
Yellow: Length of the item now being selected by arrow
Red: Excess over the capacity
TOTAL 105MIN
MAX FR240
DVM700ER_00.book Page 47 Wednesday, September 20, 2006 10:03 AM