JVC SR-DVM700ER - Manual (Page 48)

Filename [DVM700ER_11Editing.fm]
Masterpage:Left+
48
EN
EDITING
Page 48 Wednesday, 20 September 2006 10:03
You can dub programmes from a camcorder or DV equipment
connected to the unit with a DV cable. The unit’s remote control
allows you the limited control of the connected camcorder or DV
equipment functions during dubbing.
The following on-screen display for DV dubbing appears when
ON SCREEN is pressed while the channel has been set to
ADVB.
A Remote control switch
To switch between the devices operable by the remote control
unit. The unit is operable when the remote icon (
)
displayed faces to the left, while the DV device is operable when
the remote icon is facing to the right.
B Auto capture button
Select to start or pause the dubbing. If ENTER is pressed when
the DV device is in the pause condition, preroll editing* where it
is possible to dub with a start time that is highly accurate will be
activated. When the DV device cannot be operated from the unit
(such as in camera mode), proceed with normal recording.
● Do not start dubbing at the portion with no time code ( A– –:– –:– –B).
* Preroll editing refers to the playback after the DV tape is slightly rewind.
(For DV devices that do not support the –1x speed, the rewinding time
may be longer.)
C Sound monitor switch
For selecting the desired sound format for dubbing.
1
Connect a camcorder or DV equipment to the [DV IN/OUT]
connector on the unit’s front panel.
2
Press DV/HDD/DVD on the unit repeatedly; or press HDD or
DVD on the remote control to select the recording deck.
● When dubbing to a DVD disc, load a recordable disc on this
unit.
3
Press INPUT SELECT +/– on the remote control or
INPUT SELECT on the unit to set the channel to
ADVB.
4
Press ON SCREEN.
● The on-screen display for DV dubbing appears.
5
Press selection keys to select , then press ENTER
to display the remote icon (facing to the right) for the DV
equipment.
6
Press REC MODE repeatedly to set the recording mode. For
DV deck, press REC MODE on the remote control to set the
recording mode.
● Each time you press REC MODE, the recording mode changes
as follows:
DV
*1 N XP N SP N LP N EP N FR (60-360 *2 , 420, 480) N
(Back to the beginning)
*1 Selectable when dubbing to the HDD deck.
*2 The value is selectable from 1 to 6 hours in 5 minutes interval by
pressing D E repeatedly after selecting AFR60–FR360B. To change
the value in 30 minutes interval, press and hold D E .
● For details on the recording mode, see ARecording ModeB
( A pg. 49).
7
Locate the point from where you want to start dubbing, then
stop or pause playback by pressing the following buttons on the
remote control:
I, N, O, o, W.
● To play back in slow speed (1/10 of the normal speed), press W
to pause playback, then press O or N.
● To play back frame-by-frame, press W to pause playback, then
press W repeatedly. Each press of W advances a frame.
● To change the playback direction, press O or N.
8
Press selection keys to select , then press ENTER
repeatedly until the desired sound track appears on the TV
screen.
SOUND1 :
Select this to record the original stereo sound played back on
the connected DV equipment.
SOUND2 :
Select this to record the dubbed stereo sound played back on
the connected DV equipment.
MIX :
Select this to record the sound of both ASOUND1B and
ASOUND2B.
● Note that this selection is not available when the source
programme is recorded in 16BIT (48 kHz) mode.
9
Press selection keys to select , then press
ENTER. The dubbing starts.
● Playback on the external DV equipment and recording on the
unit should start simultaneously.
● To pause dubbing, press selection keys to select ,
then press ENTER. Both the unit and the external DV
equipment pause dubbing. Pressing
W on the unit also works
the same way.
10
Press selection keys to select , then press
ENTER. Then press o. The DV equipment stops.
11
Press selection keys to select , then press
ENTER.
12
Press o twice on the remote control to stop dubbing.
● Both the unit and the external DV equipment stop dubbing.
NOTES:
● To create chapters (marks) automatically, set ADV AUTO
CHAPTERING B to AONB. (A pg. 58)
● Dubbing copyright guarded programmes is not possible.
● Original DV information such as the recording date and time are
not recorded.
● The superimposed indication during the operation or dubbing is
not recorded.
● If the dubbing is paused while the channel is set to ADVB, you
cannot switch channels.
DV Dubbing (HDD & DVD Deck Only)
NOTE:
When connecting the unit to a device equipped with a DV input
connector, be sure to use the optional DV cable (VC-VDV 204U).
To [DV IN/OUT]
DV cable
(VC-VDV 204U)
(not supplied)
Camcorder
DV connector
Your unit
DV equipment
L – R
SOUND1
0:00 1:00 2:00 GR-DV3500
GR-DV3500 DV
HDD
00:00:00. 00
12bit JVC
00:00:00. 00
DV
FR360
DV DV 1 2
A B C
DVM700ER_00.book Page 48 Wednesday, September 20, 2006 10:03 AM