JVC RK-LP55U - Manual (Page 13)

IT
ALIANO
ESP
AÑOL
FRANÇAIS
DEUTSCH
ENGLISH
E-13
White paint adjustment
To adjust the white balance more precisely by
varying the B and R channel’s gain after auto
white balance has been executed.
1.
Set the white balance mode to AAUTO1B or
AAUTO2B. (AWHITE BALANCE MODE
SETTING
B (A pg. 11))
2. Set the mode to APNT ONB with FUNC1 button
C. (W.PAINT LED lights.)
● If APNT OFFB is selected, the white balance is
set to the value obtained by the auto white
balance adjustment, (In this case, controls
have no effect.)
3.
Vary the B or R channel level with the WHITE
PAINT control L to adjust the white balance as
desired.
NOTE:
If auto white balance is executed with
APNT ONBselected and the procedure is
completed properly or fails as
AOBJECT ERRORB,
the setting will automatically switch to APNT OFFB
and the B or R channel level will be restored to the
center position value.
Manual white balance adjustment
To adjust the white balance manually by varying
the B or R channel’s gain.
1. Set the white balance mode to AMANUALB.
2. Vary the B and R channel levels with the
WHITE PAINT controls L to adjust the white
balance as desired.
NOTE:
Function of WHITE PAINT controls L
The last-set WHITE PAINT level can be stored,
allowing you to obtain the same level as last used
even if the control’s position has been changed.
However, once the control is turned, the memory
is canceled and the level changes to correspond
to the control's position.
o GAIN (SENSITIVITY) SETTING
● To select the camera’s sensitivity.
Available setting variations
The following 3 settings are possible.
dB mode, ALC + EEI, ALC.
1. Press GAIN button H.
● The LCD shows AGAINB with current setting.
2. Set the gain mode with FUNC2 button D.
● Each time is pressed, the mode changes
from dB mode N ALC + EEI NALC N
dB mode N ... ; pressing changes the
modes in reverse order.
● In the AdB modeB, the current gain setting is
indicated to the left.
● If any mode other than A0 dBB is set, the GAIN
LED lights.
● When gain mode is set to AALC + EEIB or
AALCB, setting of iris mode using ALC IRIS
SET is possible. (A pg. 18,
AREMOTE
CONTROLLER OPERATION MODE
SETTINGS
B)
3.
In the AdB modeB, select the dB value using
FUNC1 button C.
● Each time is pressed, the mode changes from
–3 dB N 0 dB N +3dB N +6dB N +9dB N
+12dB N +15dB N +18dB N LOLUX; pressing
changes the modes in reverse order.
● If any mode other than A0 dBB is set, the GAIN
LED lights.
● The dB value that is not compatible with the
camera will not be displayed.
NOTE:
When the random trigger mode is set to ON,
AALC
+ EEI B mode is not available.
To engage the AALC + EEIB mode, first release the
random trigger mode, then reset as necessary.
FUNC1
WHITE BALANCE
PNT ON AUTO1
Selects APNT ONB.
WHITE BALANCE
MANUAL
GAIN
GAIN
0dB dB mode
Press GAIN button.
FUNC2
Selects the mode.
GAIN
0dB dB mode
FUNC1 FUNC2
Selects the gain.
RM-LP55_U_E.book Page 13 Monday, July 25, 2005 2:57 PM