JVC XV-NA7SL - Manual (Page 13)

Getting started
Getting started
11
XV-NA7SL/LET0212-004A/English
The unit supports the linear PCM multichannel format of DVD AUDIO and can feed multichannel audio output signals
from the six analog AUDIO OUT jacks.
It is also equipped with the DTS and Dolby Digital decoders. So you can enjoy any type of the high quality surround
sounds by connecting the unit to an amplifier/receiver equipped with the 5.1-channel inputs of an amplifier or receiver
using the supplied audio cables.
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units.
To connect to an amplifier/receiver equipped with 5.1-channel inputs
NOTE
• When using the 5.1-channel outputs of the unit, set the [ANALOG OUT] in the [AUDIO] preference display to [MULTI
CHANNEL] (see page 60). If you select [EXPERT] in the [SPK.SETTING] preference display, you can control the audio output
balance of the speakers (see page 61).
AUDIO IN
RIGHT
FRONT
LEFT
REAR
RIGHT
LEFT
CENTER
SUBWOOFER
AV COMPU LINK
AV OUT
PCM / STREAM
COAXIAL SUBWOOFER
CENTER
LEFT
RIGHT
REAR FRONT
OPTICAL
VIDEO
S-VIDEO
DIGITAL OUT AUDIO OUT
COMPONENT
Y P B P R
VIDEO OUT
VIDEO SIGNAL SELECTOR
Y/C REMOTE
NTSC PAL
VIDEO
/S-VIDEO
/AV OUT PAL COMPONENT
COMP. /RGB
The unit
Amplifier or receiver
Audio cable (supplied)
White Red
White
Red
Audio cable (supplied)
White Red
White Red
Yellow
White
Red
White
Red
Audio/video cable
(supplied) Yellow
XV-NA7SL(B).book Page 11 Wednesday, July 31, 2002 1:00 PM