JVC KW-NT1 - Manual (Page 68)

68
ENGLISH
Menu items Selectable settings
Audio
Fader/Balance Fader: Adjust the front and rear speaker output balance.
• F6 to R6; Initial 0
– When using a two-speaker system, set the fader to the center (0).
Balance: Adjust the left and right speaker output balance.
• L6 to R6; Initial 0
Press [
5/∞/2/3 ] or drag the cursor to adjust.
• To set the fader and balance to the center (0), press [Center].
Equalizer Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/
User1/User2/User3 (
☞ page 67)
Subwoofer/HPF Adjust the subwoofer output level, Cross Over, and High Pass Filter.
Press [Enter] to adjust each setting.
• Level: Adjust the subwoofer output level.
–6 to +8; Initial 0
• Cross Over: Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz, 150Hz
• High Pass Filter:
On: Select when the subwoofer is connected.
Through: Select when the subwoofer is not connected.
Adaptive Volume When this function is activated, the System automatically increases the
volume level (both for guidance and audio) as the car speeds up.
Off, Min, Mid, Max
Telephone Muting * 1 Muting1, Muting2: Select either one which mutes the sounds while
using the cellular phone.
Off: Cancels.
Amplifier Gain You can change the maximum volume level of this unit.
High: VOL 0 to 20 (for guidance)/VOL 00 to 50 (for audio)
Low: VOL 0 to 15 (for guidance)/VOL 00 to 30 (for audio)
(Select this if the peak power of the speakers is less than 50 W.)
Off: Deactivates the built-in amplifier (VOL 0 to 20 for guidance/VOL 00
to 50 for audio.)
* 1 The TEL MUTING lead connection is required. (
☞ Installation/Connection Manual)
AV menu items
Cursor
EN_KW-NT1[J]f.indb 68 EN_KW-NT1[J]f.indb 68 09.3.24 6:20:16 PM 09.3.24 6:20:16 PM