JVC CA-UXQ1S - Manual (Page 33)

Introduction
30
English
Editing MDs
NOTE
• Number of characters that can be entered to an MD
You can enter up to 1,792 characters to each
MD, with up to 61 characters to each track.
However, the actual number of characters that
you can enter is less than the number indicated
here because of restrictions of the MD writing
method.
Spaces are counted as characters.
When you use long-play stereo recording (LP2 or
LP4), the larger the number of tracks is, the
smaller the number of characters that you can
enter, because "LP: " and 4 spaces are automati-
cally added to each track.
You can set this product so that "LP: " is not
added to tracks. (
page 25)
Example: When editing 120 tracks recorded
using long-play stereo recording to an
MD, you can enter 10 characters to
each track.
• You cannot edit a title consisting of 62 or more
characters. When you want to edit a title contain-
ing 62 or more characters, edit the title on the
equipment on which the title was entered.
• You can set a title during recording.
• While recording from a CD (except when
recording only one track from a CD), you can
enter up to 16 track titles before recording
finishes.
• If you do not press before recording fin-
ishes, the entered titles are not stored.
• During group recording, you can enter titles for
the group.
Example: To enter "F"
1) Press repeatedly until [ ] appears on
"A".
2) Press repeatedly to display "F".
• Several characters are assigned to one button.
Press the button repeatedly until the desired
character is displayed.
• For the available characters, refer to "Available
Characters" shown on the right.
To move the character entry position
• Press or .
• When you want to enter "NO", "TV" or two char-
acters which are assigned to one button, enter
the first character, press to move the char-
acter entry position to the right, and then enter
the second character.
To erase a character
• Move the character entry position to the charac-
ter you want to erase, and press .
To enter a space
• Select the space from "Symbol" ( the chart
below). You can also enter a space at the end of
a title by pressing .
To quit title entry
• Press or . The entered titles are not
stored.
*Available symbols
Entering Titles
Character entry position
(flashing)
Available character types:
[ ] indicates the selected character type.
[A]:Uppercase characters or symbols
[a]:Lowercase characters or symbols
[1]:Numerical characters
Available Characters
Button
Symbol*
Numerical
character
Uppercase
character
Lowercase
character
Symbol*
ABC
DEF
GHI
JKL
MNO
PQRS
TUV
WXYZ
abc
def
ghi
jkl
mno
pqrs
tuv
wxyz
1
2
3
4
5
6
7
8
9
0
Space
UX-Q1[UB]-10.fm 30 ページ ２００４年８月１０日 火曜日 午後５時５分