JVC UXQD90S - Manual (Page 111)

50
Conveni
e
nt F
uncti
ons
In step 2 on page 48, select the timer number you
want to cancel, and then press .
Even when you cancel the playback timer, the set-
ting remains stored.
In step 2 on page 48, select the timer number you
want to activate, and press . Then turn off the
main unit.
In step 2 on page 48, press repeatedly. If you
want to quit checking the playback timer,press
.
Set the playback timer again from step 1 on page
48.
NOTE
• When you want to activate two or three playback
timers, leave a blank time of 2 or more minutes
between the ending time of the first playback timer
and the starting time of the second playback timer.
If the blank time is less than 2 minutes, the second
playback timer does not work.
• When the power plug is disconnected or the
power is interrupted, the playback timer settings
may be lost. If the settings are lost, set the clock
and playback timer again.
• When you operate the playback timer with a DVD
VIDEO, DVD AUDIO or VCD, sound and video
may not be played back automatically. A DVD
VIDEO, DVD AUDIO or VCD may contain a disc
menu that appears first when played back.
Sound or video will not come out before you
select the desired item to be played back on the
disc menu.
Auto Standby
If no sound is produced for 3 minutes when the
disc or cassette tape is selected as a sound
source, the main unit automatically turns off.
■When the disc or cassette tape is selected
as a sound source
Press .
When playback or recording finishes, auto standby
starts the countdown (the "A. STANDBY" indicator
flashes). When no operation is carried out within 3
minutes, the main unit automatically turns off.
When you start playback or recording within 3 min-
utes, auto standby starts the countdown again
after playback or recording finishes.
When an operation other than playback and record-
ing finishes and no operation is carried out within 3
minutes, the main unit automatically turns off.
"A. STANDBY OFF" indicator starts to flash 20
seconds before the main unit is to turn off.
Press once again.
NOTE
• Leaving the volume at "0" is not the same as produc-
ing no sound, and therefore does not start the auto
standby function.
For the locations of remote control
buttons, refer to page 46.
Canceling the playback timer
function
Activating the playback timer again
Confirming the playback timer
Changing the playback timer
"A. STANDBY" stands for "Auto Standby".
Auto standby indicator
Auto standby performance
Canceling auto standby
UX-QD90[UG_UX].book Page 50 Tuesday, September 6, 2005 11:32 AM