JVC UXQD90S - Manual (Page 76)

Introduction
15
(Continued)
Connections
You can enjoy pictures of better quality using the
following cord instead of the supplied video cord.
You can enjoy better quality pictures than when
using the S-video cord.
CAUTION
• Use one of either the S-video cord or the
component video cord. If both cords are used,
pictures may not be played back properly.
NOTE
• In order to enjoy pictures with the progressive
mode ( page 19), the TV is required to have
progressive video input.
• If the component video input jacks of your TV are
BNC type, use a plug adapter (not supplied) to
convert the plugs.
• After making all other necessary connections,
connect in the power plug.
• If not using this product for a long period, discon-
nect the power plug from the AC outlet for safety
and to save electricity.
• The clock setting will be lost after the power plug
has been disconnected or the power is inter-
rupted for more than 1 minute. The timer set-
tings will be lost when the power is interrupted.
When the power is restored, set the clock and
the timers again.
■When the power is turned off
Hold down on the main
until "DEMO CLEAR" appears.
Disconnecting and then reconnecting the power
plug will not start the demonstration display.
NOTE
• To activate the demonstration display again, hold
down on the main unit while the power is
off until "Hello" appears.
• Activating the demonstration display turns on the
main unit.
• When you press a button on the main unit,
"DEMO OFF" appears in the display window and
the demonstration display is canceled. (Discon-
necting and then reconnecting the power plug
will start the demonstration display again.)
Connect all necessary parts before connecting the power plug.
When a Clearer Picture Is
Desired
Connecting by using the S-video cord
TV Main unit
S-video cord
(not supplied)
Connect the ends of S-video cord making sure that each
end matches its compatible terminal.
Connecting by using the component
video cord
TV
Main unit
Component video cord
(not supplied)
Connecting the Power Plug
Disabling the Demonstration
Display
When you connect the power plug into the AC
outlet, "DEMO START!" appears in the display
window and the demonstration display starts.
Before using the main unit, turn off the demon-
stration display by setting the function to "DEMO
CLEAR".
AC outlet Main unit (rear view)
UX-QD90[UG_UX]-03.fm Page 15 Monday, September 12, 2005 12:02 PM