JVC UXQD90S - Manual (Page 82)

Introduction
21
(Continued)
Listening to Radio Broadcasts
1
Press to select "FM" or "AM".
Example: While an FM radio broadcast is
received
2
Press or repeatedly to
select a radio station (frequency).
• You can also select a radio station using the
automatic tuning.
• When the main unit has received an FM
stereo broadcast, "STEREO" lights up.
You can store up to 30 FM radio stations and up to
15 AM radio stations.
■While the broadcast from the radio station
you want to preset is being received
1
Set the remote control mode
selector to AUDIO.
2
Press .
• The preset number flashes for approxi-
mately 5 seconds.
3
While the preset number is flash-
ing, press the number buttons
(
- or ) to select the pre-
set number you want to use.
• Refer to "Using the number buttons"
( page 16).
• You can also select the preset number by
pressing or .
4
While the selected number is
flashing, press
or .
• "STORED" appears and the selected radio
station is stored.
NOTE
• The type of FM reception (stereo/monaural) is also
stored ( on the left).
• When you store a radio station to a preset num-
ber to which another radio station has previously
been stored, the newly set radio station replaces
the previously stored radio station.
■While an FM or AM broadcast is being received
1
Set the remote control mode
selector to AUDIO.
2
Use the number buttons to select
the preset number of the radio sta-
tion to which you want to tune in.
• Refer to "Using the number buttons"
( page 16).
• You can also select the preset number by
pressing or .
For the locations of remote control
buttons, refer to page 20.
Selecting a Radio Station
Stereo indicator Preset number ( on the right)
Frequency
Automatic tuning:
Hold down or until the fre-
quency starts changing, and then release
the button.
When the main unit has received a broad-
cast, the frequency automatically stops
changing.
To quit the function while searching for a
broadcast, press
or .
Switching the FM reception (stereo/
monaural):
If an FM stereo broadcast is difficult to hear
because of noise, you may be able to hear
more easily by pressing
to switch
the sound to monaural reception. In this
case, "MONO" lights up. To return the sound
to stereo reception, press
again.
Storing Radio Stations (Preset)
Tuning In to a Preset Radio Station
UX-QD90[UG_UX]-03.fm Page 21 Monday, September 12, 2005 12:02 PM