Spirit XBR95 - Manual (Page 11)

7
Fitness Bike
XBR95
1. Install the Seat (61) on the Seat Carriage (4) with four Phillips Head Screws (98). Tighten with the Phillips Head
Screw Driver (114).
2. Attach the Seat Handle Bar (6) to the Seat Carriage (4) with the four Hex Head Bolts (71), four Flat Washers
(77), and four Nyloc Nuts (89). Tighten with the wrenches provided (112 & 130).
3. Plug the Hand Pulse Sensor Cables (27) into the rear two holes on the left side of the rear
plastic cover. Plug the Handlebar resistance cables (150) into the remaining front hole.
4. Attach the Front Stabilizer Cover (32) and the Rear Stabilizer Cover (37) to the Main Frame with four Phillips
Head Screws (99). Tighten with the Phillips Head Screw Driver (114).
HARDWARE
STEP 3: Seat & Handle Bar
#98.ƒM6 x 15mm
Phillips Head Screw
(4 pcs)
#89.ƒ3/8” x 7T
Nyloc Nut
(4 pcs)
#99.ƒM5 x 12mm
Phillips Head Screw
(4 Pcs)
#77. 3/8” x 19 x 1.5T
Flat Washer
(4 Pcs)
#71. 3/8” x 1-3/4” Hex
Head Bolt
(4 Pcs)