Important safeguards, Temperature monitor function, Lamp monitor function – Sharp XG-P25X User Manual
Page 9: Using the carrying handle, Using the kensington lock
Temperature Monitor Function
If the projector starts to overheat due to setup problems
or a dirty air filter, “TEMP.” and “ ” will blink in the lower-
left corner of the picture. If the temperature continues
to rise, the lamp will turn off, the TEMPERATURE
WARNING indicator on the projector will blink, and after
a 90-second cooling-off period the power will shut off.
Refer to “Lamp/Maintenance Indicators” on page
• The cooling fan regulates the internal temperature, and its
performance is automatically controled. The sound of the
fan may change during projector operation due to changes
in the fan speed.
Lamp Monitor Function
When the projector is turned on after the lamp has been used
for 1,400 hours, “LAMP” and “ ” will blink in the lower-left
corner of the picture to advise you to replace the lamp. See
for lamp replacement. If the lamp has
been used for 1,500 hours, the projector power will
automatically turn off and the projector will enter standby
mode. Refer to “Lamp/Maintenance Indicators” on page
Using the Carrying Handle
When transporting the projector, carry it by the carrying
handle on the side.
• Always put on the lens cap to prevent damage to the lens
when transporting the projector.
• Do not lift or carry the projector by the lens or the lens cap
as this may damage the lens.
Using the Kensington Lock
This projector has a Kensington Security Standard
connector for use with a Kensington MicroSaver Security
System. Refer to the information that came with the
system for instructions on how to use it to secure the
02.3.19, 7:15 PM