Sony DSR-DR1000 - Manual (Page 42)

42
Playback
14
To set point B, refer to steps 5 to 13 . (Select
“REPEAT END” in step 5 , “B POINT” in step 7, and
“B PRESET” in step 9 .)
15
Press the MENU button to close the menu.
Repeat Playback —Automatic
Cyclical Playback
Proceed as follows to perform automatic cyclical playback
of recording (repeat playback) between selected start and
end points.
1
Set the desired repeat start and end points with the
REPEAT FUNCTION menu item (see page 64).
You can set points A and B as start and end points by
following the procedure described in “Setting Points
A and B for Repeat Playback” on page 39.
2
Set the REPEAT MODE menu item (see page 64) to
ON.
The REPEAT indicator lights.
3
Press the SET button to save the new setting and close
the menu.
4
Press the PLAY button.
The unit repeats playback between the repeat start and
end points set in step
1 .
Connecting Multiple Units for Simultaneous Playback (Multi-Simultaneous
Playback)
You can connect multiple DSR-DR1000/DR1000P units
in a cascade connection for simultaneous playback of
various different scenes. The figure below shows how to
make cascade connection using the REMOTE IN(R)
connector and the REMOTE OUT(P) connector. In this case, the REMOTE I/F menu item (see page 72) must be
set to 9PIN(PARA).
To control all of the cascaded units from a single unit,
press the EXT button on the controlling unit, turning it on.
Set the control mode selectors on other units to REMOTE.
SUPER
b)
b)
a) a) a) a)
REMOTE OUT(P) REMOTE OUT(P)
REMOTE
IN(R)
MONITOR SUPER MONITOR
Recorder 1
(controlling unit)
Monitor Monitor
Recorder 2
Monitor
Recorder n
a) 75 Ω coaxial cable
b) 9-pin remote control cable